Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

"no snmp trap link-status" this command is accepted but a syslog msgs seen

CAT 6500 running IOS version:

s72033-pk9sv-mz.122-18.SXD6.bin

Partial config:

===============

interface GigabitEthernet2/23

bandwidth 1000000

ip address 10.x.x.x 255.255.255.252

no ip redirects

no ip unreachables

no ip proxy-arp

ip authentication mode eigrp 45 md5

ip authentication key-chain eigrp 45 xxxxx

ip summary-address eigrp 45 10.x.x.x. 255.255.0.0 5

ip summary-address eigrp 45 10.y.y.y 255.255.0.0 5

load-interval 30

delay 1

udld port aggressive

no snmp trap link-status

Note that logging event link-status is disabled by default so "no logging event link-status" command is not displayed in this configuration.

The config would normally have a line that reads logging event link-status to enable link status events being logged.

Also note that snmp link status events are disabled to be thorough but I believe the error is being generated by syslog as indicated below, in this instance when we bounced Gi2/23 interface.

Sep 3 08:31:39 bnz-80boul-l10-cs-01.bnz.tcnz.sytecnms.net [local7.notice]: 513: Sep 3 08:32:34.165: %LINEPROTO-SP-5-UPDOWN: Line protocol on Interface GigabitEthernet2/23, changed state to down

Sep 3 08:31:39 bnz-80boul-l10-cs-01.bnz.tcnz.sytecnms.net [local7.notice]: 514: .Sep 3 08:32:34.173: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 45: Neighbor 10.67.67.2 (GigabitEthernet2/23) is down: interface down

Sep 3 08:31:40 bnz-80boul-l10-cs-01.bnz.tcnz.sytecnms.net [local7.err]: 515: Sep 3 08:32:34.173: %LINK-SP-3-UPDOWN: Interface GigabitEthernet2/23, changed state to down

Sep 3 08:34:19 bnz-80boul-l10-cs-01.bnz.tcnz.sytecnms.net [local7.err]: 516: Sep 3 08:35:14.553: %LINK-SP-3-UPDOWN: Interface GigabitEthernet2/23, changed state to up

Sep 3 08:34:20 bnz-80boul-l10-cs-01.bnz.tcnz.sytecnms.net [local7.notice]: 517: .Sep 3 08:35:14.575: %DUAL-5-NBRCHANGE: IP-EIGRP(0) 45: Neighbor 10.67.67.2 (GigabitEthernet2/23) is up: new adjacency

Sep 3 08:34:20 bnz-80boul-l10-cs-01.bnz.tcnz.sytecnms.net [local7.notice]: 518: Sep 3 08:35:14.557: %LINEPROTO-SP-5-UPDOWN: Line protocol on Interface GigabitEthernet2/23, changed state to up

1 REPLY
New Member

Re: "no snmp trap link-status" this command is accepted but a sy

So why are syslog messages generated for Gi2/23 in spite of saying no snmp trap link-status under this interface.

More of the config:

=====================

logging trap notifications

logging source-interface Loopback0

logging 172.x.x.x

!snmp-server community RO 98

snmp-server trap-source Loopback0

snmp-server enable traps snmp authentication linkdown linkup coldstart warmstart

972
Views
0
Helpful
1
Replies