Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

"show ip eigrp topo" feature request

Guys,

Does anyone know if you can do a show ip eigrp topo and get all of the information for all prefixes.

Ie, if you want to do the following - BUT FOR ALL PREFIXES in the topo table and not just one route.

router>sh ip eigrp topo 123.123.123.0 255.255.255.252

IP-EIGRP topology entry for 123.123.123.0/30

State is Passive, Query origin flag is 1, 2 Successor(s), FD is 156928

Routing Descriptor Blocks:

122.122.122.65 (FastEthernet1/0/0), from 122.122.122.65, Send flag is 0x0

Composite metric is (156928/131328), Route is External

Vector metric:

Minimum bandwidth is 100000 Kbit

Total delay is 5130 microseconds

Reliability is 255/255

Load is 1/255

Minimum MTU is 1500

Hop count is 4

External data:

Originating router is 222.222.222.6

AS number of route is 1

External protocol is EIGRP, external metric is 131328

Administrator tag is 1 (0x00000042)

121.121.121.65 (FastEthernet5/0/0), from 121.121.121.65, Send flag is 0x0

Composite metric is (156928/131328), Route is External

Vector metric:

Minimum bandwidth is 100000 Kbit

Total delay is 5130 microseconds

Reliability is 255/255

Load is 1/255

Minimum MTU is 1500

Hop count is 4

External data:

Originating router is 222.222.222.5

AS number of route is 1

External protocol is EIGRP, external metric is 131328

Administrator tag is 1 (0x00000042)

router>

I know that you can do a show ip eigrp topo all and get some output for all entries in the topo but you dont get all the external/internal info in the output.

This is for a routing analysis excercise.

Many thx

Ken

2 REPLIES

Re: "show ip eigrp topo" feature request

Hello Ken,

unfortunately there is no command that displays all the detailed routes in the topology table, the only way to get a detailed description is by entering an IP address...

Regards,

GNT

New Member

Re: "show ip eigrp topo" feature request

Hey GNTs,

Thx for that (good website btw)

So, I have a router that has two eigrp procs on, and I want to be able to easily be able to list a route that is in a partical AS and is internal to that AS. Problem being mutual redist on the router, so AS1 goes into AS2 and vice versa.

so.... I guess the best way is

show ip route eigrp | incl 90/

I assume there is no other way to do a show ip route eigrp internal?

Many thx btw and will rate the posting :)

Regards,

Ken

557
Views
0
Helpful
2
Replies
CreatePlease to create content