I believe that the suggestion by Edison that it is a recursive route is likely to be the correct answer. But if it turns out not to be a recursive route then another possibility to consider is the possibility that Policy Based Routing has been configured and is sending the traceroute differently from what is indicated in the routing table.
If it is not an issue with a recursive route then could you check for the configuration of PBR?
I think there will be a lot of differences between those two because doesn't the traceroute return the actual interface addresses that it passes through instead of the OSPF addresses used to populate the routing table (RID)?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.