Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

"Show Power" on Catalyst 4510 not reporting fault.

Hi,

I've had a recent issue where a customer has reported the "output fail" red LED being lit on a PSU but when I check the device logs there are no entries to say there is a problem. I've attached the "show power" output and all looks ok until you have a look at the entry for inline power against PS2 which has an entry of 0 instead of 50.

We're not currently using the inline power function but I was surprised to not even receive an alert and yet the LED was lit. Is this a known reporting bug?

Thanks in advance for any help.

312
Views
0
Helpful
0
Replies