Hi, we have an enterprise campus made up of 3 buildings. We recently installed a wireless bridge/radio (Tranzeo) to connect two of the buildings. The Radio is terminated on a 2950 switch at the main building. The problem is that when we power up both the Radio and 2950 Switch, the Radio's switchport doesn't come up after the Switch completes its power on process. But if you power the Radio off and on again (with the Switch already on) the port comes up. We have tried adjusting the duplex and speed settings on both the Radio and Switch but the problem persists. Please assist. Thanks a million.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...