Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RADIUS Authentication on 2960

Wet setup MS IAS Server according to this article:

http://articles.techrepublic.com.com/5100-10878_11-6180954.html?tag=rbxccnbtr1

I still can't use my Active Directory user name and password to log into the switch. Any pointers ? Thank you.

4 REPLIES
New Member

Re: RADIUS Authentication on 2960

New Member

Re: RADIUS Authentication on 2960

Thank you for the reply, I have followed everything but its not working still.

How do I know which port?

ip radius source-interface f0/0

Re: RADIUS Authentication on 2960

The ip radius source-interface command allows you to statically configure the source port or IP address for the outbound radius requests from your switch. Generally you would source this from your management VLAN or loopback interface.

HTH,

Mark

New Member

Re: RADIUS Authentication on 2960

Latest update on this issue. I was able to see it in the logs that my user name is trying to authenticate but I was getting "Access Denied" because authentication protocols weren't matching. Do I need to specify some where in the switch to use PAP or PEAP?

3096
Views
0
Helpful
4
Replies