Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

radius config

I am trying to set up Radius on a cat4506 with IOS version 12.2 but none of the radius-sever commands work. There isn't anything about radius when using the "?" in config mode. Any ideas?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: radius config

You need to enable aaa by entering the command:

aaa new model

After that the aaa authorization, authentication and accounting commands should be available as well as the radius-server commands.

HTH

Andy

2 REPLIES

Re: radius config

You need to enable aaa by entering the command:

aaa new model

After that the aaa authorization, authentication and accounting commands should be available as well as the radius-server commands.

HTH

Andy

Re: radius config

see below for full radius config. the config will also fallback to local authentication if your radius server is down.

aaa new-model

radius-server host (your radius server ip) auth-port 1812 acct-port 1813

radius-server key (your radius secret key

radius-server source-ports 1645-1646

username **** password ******

aaa authentication login default group radius local

aaa authentication login console local

Franco

Please rate if this helps.

147
Views
0
Helpful
2
Replies
CreatePlease to create content