10-23-2006 02:10 AM - edited 03-05-2019 12:23 PM
Hi,
i have set up a RADIUS server(freeradius) in linux,now you i tell my switch to authentication via radius server? i mean the user name & password will be on the radius server. switch should prompt for user name & password so that it will get the info from the radius server, what are the commands should i specify in the cisco 2950?
10-23-2006 03:05 AM
Hi, the next url can be helpful for you:
Regards
10-23-2006 05:16 AM
thankz for ur reply,
i am bit confussed about the radius setup in the switch, is that configuration below mentioned will be sufficient for a very simply authenctication?
radius-server host 10.1.1.1 nonstandard
radius-server key
my requirement, username & password will be set on the radius server, all the switches should log in with the username & password mentioned on the radius server,
10-23-2006 05:52 AM
Hi, you'll need to specify an AAA group and then the aaa external server (the radius)
You can see:
http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a0080093c81.shtml
Take a general look to the document and specially to your case, Login authentication:
http://www.cisco.com/en/US/tech/tk59/technologies_tech_note09186a0080093c81.shtml#login_auth
Hope this helps you.
Pls, rate the post if useful.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: