I have a 4510R Device. Also some WS-C3750 Edge Switches connected to them. So if I connect a C3750 Switch to the 4510R Switch an another C3750R Switch to the 4510R Switch and connect both C3750 Switches together I have a loop. I have configures the rapid spanning tree protocol and all works weel and fast. On all Interfaces-Links I have a green LED. Is this right, ore shoud one link-LED be red (the one which his on standby)? thanx alot for your help!
You will not have an amber light unless the ports are in access mode and blocking. If they are trunking all lights will be green if the ports are operational. Use the "show span" command to find out which ports have a blocked state. You will only see it being blocked on one side.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...