Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Rate limit VLAN on Cisco 3560

Hello

I`m trying to rate limit some specific traffic passing through a 3560 switch on some VLANs.

What I have done is create an access list:

access-list 101 permit icmp any any echo

access-list 101 permit icmp any any echo-reply

Then I set a rate limit on the VLAN interface:

rate-limit input access-group 101 128000 8000 8000 conform-action transmit exceed-action drop

rate-limit output access-group 101 128000 8000 8000 conform-action transmit exceed-action drop

CEF is enabled.

But this does not rate limit the traffic like it should, what am I missing here?

5 REPLIES
Super Bronze

Re: Rate limit VLAN on Cisco 3560

From latest 3560 configuration guide:

Unsupported Interface Configuration Commands

rate-limit

You might want to consult configuration guide QoS chapter's section on "Policing on SVIs", e.g. http://www.cisco.com/en/US/docs/switches/lan/catalyst3560/software/release/12.2_50_se/configuration/guide/swqos.html#wp1766801, for your IOS.

Re: Rate limit VLAN on Cisco 3560

I recall having same issues on this platform. I used following workaround:

1-I know 3560 can police inbound, so I used a service policy on physical port. referring to a class map & ACLs.

2-for outbound, I used the upstream port ad policed its traffic inbound.

HTH

Sam

New Member

Re: Rate limit VLAN on Cisco 3560

Thank you for quick reply.

I have done some VLAN filter, bot nothing like in the linked article.

How would I do this config for desired results?

Super Bronze

Re: Rate limit VLAN on Cisco 3560

New Member

Re: Rate limit VLAN on Cisco 3560

I am a little fuzzy but I believe you have to turn on "mls qos" have you done this?

1872
Views
8
Helpful
5
Replies