Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Rate limiting on a Catalyst 5509 switch?

Anyone know if this is possible, and if so, have any sample configurations to do it? I've been digging around Google and not coming up with a whole lot, and considering the switch is on End-of-life status, Cisco isn't supporting it either.

Edit: We're looking to set it up on a per-port basis.

Thanks!

-Glen

3 REPLIES

Re: Rate limiting on a Catalyst 5509 switch?

Glen, this is discuntinue product, you will have to do a little better, most of newer catalyst switches can do per port rate limiting , Qos etc.. , go to product link bellow and pick product look in data sheets and software feature information , it will indicate its capability in this technology.

For example I see these support rate limiting Catalyst 2960 LAN-base, 3560, 3560-E, 3750 etc..

For details refer to data sheets and/or software features ( Granular rate limiting)

http://www.cisco.com/en/US/products/hw/switches/index.html

HTH

Jorge

New Member

Re: Rate limiting on a Catalyst 5509 switch?

Jorge,

Thank you for the response, but just so I am 100% clear and can report the correct information to my boss....are you saying the 5509 is not capable of rate limiting on a per port basis?

Thanks!

-Glen

Re: Rate limiting on a Catalyst 5509 switch?

Hi Glen, base on data sheets reports on bellow link , no it is not supported, doing a search on product rate limiting is not found in any of 5500 models.

ALL 5500 Series data sheets report

http://www.cisco.com/en/US/products/hw/switches/ps679/products_data_sheets_list.html

rate any helpfull post if it helps.

HTH

Jorge

118
Views
0
Helpful
3
Replies
CreatePlease to create content