I have a bit of an issue with a 4928-10ge switch. Basically this switch is connected to a wan internet router which has a 1gb internet fibre connection.
Ive connected the 4928 to the end of this wan router but I need to limit each port to just 40mb each. Ive tried creating a policy map but im still getting 189mb down and over 100mb upload to some servers. Also when I go into the class map, I cant use the bandwidth command which I beleive you could use before?? Can someone please see where im going wrong with this?? Also the srr queue command doesnt work on the interface either. Thanks
System image file is "bootflash:cat4500-entservices-mz.122-54.SG1.bin"
class-map match-all class1
match access-group 101
police 40000000 bps 1000 byte conform-action transmit exceed-action drop
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...