Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

rate-limiting or traffic shaping on 2950 switch.

I need to limit the bandwidth of Ethernet port of 2950 switch to 1 Mbps. Is there any option in 2950 for rate-limiting or traffic shaping by which the same could be possible.

1 REPLY
New Member

Re: rate-limiting or traffic shaping on 2950 switch.

Hello,

There is indeed an option to do this through a policer configured through a policy-map, as described here:

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12122ea7/scg/swqos.htm#wp1045516

1 Mbps is in fact the lower bound of a configurable policer rate, so you are in luck. Bear in mind though that you have to have an EI 2950 switch in order for this to be possible. I hope this helps.

*Please take a moment to rate this post if it did indeed help you. Thank you!

Regards,

Lucas

1155
Views
0
Helpful
1
Replies
CreatePlease login to create content