Rate Limiting specific ports on the Cisco 2960CG

[demetrickn]

Hello ,

I'm trying to limit the bandwidth on certain ports to 3Mbps and others 1Mbps for a project, however when I do a bandwidth test from a website  the speed on the router  doesn't seem to change it's as if the changes over telnet aren't actually affecting the swtich's qos settings. I have verified that the policy is attached to the interface and the settings are correct as well.

Router

Telnet address: 10.xxx.xx.xx

Password:

Current Settings :

ciscoqe>show policy-map

       Policy Map POLICY_SLAP

       Class CLASS_SLAP

         police 2000000 100000 exceed-action drop

   GigabitEthernet0/1

ciscoqe>show policy-map interface

       Service-policy input: POLICY_SLAP

   Class-map: CLASS_SLAP (match-all)

     0 packets, 0 bytes

     5 minute offered rate 0 bps, drop rate 0 bps

     Match: access-group name ACL_SLAP

   Class-map: class-default (match-any)

     0 packets, 0 bytes

     5 minute offered rate 0 bps, drop rate 0 bps

     Match: any

       0 packets, 0 bytes

       5 minute rate 0 bps

[Dejan Puhar]

Hi,

you can check sho mls qos interface XXX

for that one where you have policy.

It is strange that you do not see any packets even in class-default.

cheers

Dejan