Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Rate Limiting specific ports on the Cisco 2960CG

Hello ,

I'm trying to limit the bandwidth on certain ports to 3Mbps and others 1Mbps for a project, however when I do a bandwidth test from a website  the speed on the router  doesn't seem to change it's as if the changes over telnet aren't actually affecting the swtich's qos settings. I have verified that the policy is attached to the interface and the settings are correct as well.

Router

Telnet address: 10.xxx.xx.xx

Password:

Current Settings :

ciscoqe>show policy-map

       Policy Map POLICY_SLAP

       Class CLASS_SLAP

         police 2000000 100000 exceed-action drop

   GigabitEthernet0/1

ciscoqe>show policy-map interface

       Service-policy input: POLICY_SLAP

   Class-map: CLASS_SLAP (match-all)

     0 packets, 0 bytes

     5 minute offered rate 0 bps, drop rate 0 bps

     Match: access-group name ACL_SLAP

   Class-map: class-default (match-any)

     0 packets, 0 bytes

     5 minute offered rate 0 bps, drop rate 0 bps

     Match: any

       0 packets, 0 bytes

       5 minute rate 0 bps

1 REPLY
Cisco Employee

Rate Limiting specific ports on the Cisco 2960CG

Hi,

you can check sho mls qos interface XXX

for that one where you have policy.

It is strange that you do not see any packets even in class-default.

cheers

Dejan

663
Views
0
Helpful
1
Replies
CreatePlease to create content