I'm trying to rate limit traffic on vlan1 for less than 1 mb. I use the following config and tried to push upto 6mb with the hope that higher than 1 mb will be dropped but it didn't happen in my case. when I do show int vlan 1 rate-limit I don't see anyting exceed or dropped. What am I doing wrong? I'm trying this on on Cisco 3560 with 12.2.52.
Switch#show int vlan 1 rate-limit Vlan1 Input matches: access-group 101 params: 8000 bps, 1500 limit, 2000 extended limit conformed 0 packets, 0 bytes; action: drop exceeded 0 packets, 0 bytes; action: drop last packet: 858339ms ago, current burst: 0 bytes last cleared 00:01:15 ago, conformed 0 bps, exceeded 0 bps
My config looks like this- this is a lab set up and i can try any suggestion access-list 101 permit ip any any interface vlan 1 rate-limit input access-group 101 8000 1500 2000 conform-action drop exceed-action drop I have also tried interface vlan 1 rate-limit input access-group 101 8000 1500 2000 conform-action transmit exceed-action drop
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.