Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Re : To check on memory on switches/router ...

Hi,

I would like to check how does one check if there is a memory issue on the switch/router ?

What commands can I use to check :-

i) memory leak

ii) buffer leak

iii) overall memory usage on the

router ....

I always use the 'sh processes memory' command to check on memory, which othe commands can supplement this to check on the switch/router memory ?

Router #sh processes memory

Total: 232163224, Used: 109466664, Free: 122696560

Thanking you in advance,

Cheers,

- sn -

4 REPLIES
Cisco Employee

Re: Re : To check on memory on switches/router ...

You can use "show mem debug leaks" command to check the memory leak.

To check memory used by specific process, you can use "show memory summary"

HTH,

Nagendra

New Member

Re: Re : To check on memory on switches/router ...

I am a curious guy, and went out writing the "show mem debug leak" command....

...and FREEZE my comnand line...

I opened another command line, to my main switch, and WOW....

"SW1#show processes cpu

CPU utilization for five seconds: 99%/100%; one minute: 80%; five minutes: 29%

"

Do it carefully :)

How do i resoved ? Clear line who performed the 1st command.

Best Regards,

Petrónio

Re: Re : To check on memory on switches/router ...

Look at the "who" command to see who is connected on what line.

Look at the "disconnect" command options to disconnect a user connected through another line.

e.g.:

router#who

Line User Host(s) Idle Location

5 aux 0 Modem Autoconfigure 00:00:03

6 vty 0 idle 00:00:30 nms

* 7 vty 1 idle 00:00:01 nms

Interface User Mode Idle Peer Address

router#disconnect ssh vty 0

router#who

Line User Host(s) Idle Location

5 aux 0 Modem Autoconfigure 00:00:00

* 7 vty 1 idle 00:00:01 nms

Interface User Mode Idle Peer Address

You may need to use different syntax if it's not an SSH connection (i.e.: use command help).

The other connection will likely timeout anyway, unless you have not configured timeouts for your lines.

New Member

Re: Re : To check on memory on switches/router ...

Router_1#who

Line User Host(s) Idle Location

1 vty 0 idle 00:02:09 172.20.0.180 -- > This was the 1st connection ( Stucked ), before "disconnected"

* 2 vty 1 idle 00:00:07 172.20.0.180 -- > This was the 2nd connection i used for "disconnect" the previous one.

Interface User Mode Idle Peer Address

Router_1#clear line 1

[confirm]

[OK]

Best Regards,

Petrónio

395
Views
0
Helpful
4
Replies