cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
465
Views
0
Helpful
2
Replies

Reasons for EIGRP Flapping

Actually we are taken the connection from ISP and configured EIGRP for network. When we given the command sh ip Eigrp neighbour, we found Eigrp neighbour ship was found to be flapped. when ever we log the calls with ISP, they just replying link is stable no issue found from our end, Please check at ur end for EIGRP flapping. Since its Data center every one restricted, so no chance for Physical disturbtion of cable. what are reasons  for EIGRP flapping. How we can find where the issue exactly? i think its jilly question but expecting interesting answers..

2 Replies 2

any replies?

Have you check the configuration ? Can we have a snippet of config from both the devices and logs were you are seeing the nighbors flapping?

What are the underlying physical interfaces? 20 p-t-p neighbors... is this perhaps on FrameRelay? If so, what is the interface utilization? Are you using EIGRP stub feature on spoke sites? If not, why not?

How is the CPU load on the hub site when the "flapping" occurs?

HTH

Regards

Inayath

*Pl zrate all usefull posts.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco