Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reconfiguring Stackwise 3750?

                   Hi, there were three 3750s in a stackwise configuration but later it was decided to remove sw #1 from the stack and make it a standlone sw. I was trying to reconfigure the new combination and tried renumbering the switches and also changed the priority but the switch #1 in a stack if 2 now, shows three switches still!?

how can I make sure that new configuration is done clean and the master switche only shows two switches with switch number 1 being master i.e. with "*"?

Please advise,

Masood

3 REPLIES
Hall of Fame Super Gold

Reconfiguring Stackwise 3750?

conf t

no switch 2 provision

no switch 3 provision

end

wr

New Member

Reconfiguring Stackwise 3750?

Thanks.

I did no switch 1 provision when they had remove/recabled the first one so I had to configure the seocnd to be the first one.

then, I used the same command to add the second one.

is there a way to remove stackwise config altogther and just add what is needed?

Thx,

Masood

Hall of Fame Super Gold

Reconfiguring Stackwise 3750?

I did no switch 1 provision  when they had remove/recabled the first one so I had to configure the seocnd to be the first one

You want the second switch to be the first what?  First switch or the master switch?

is there a way to remove stackwise config altogther and just add what is needed?

You want to remove the config of the existing switch stack or just the one you've pulled out?  If it's the one you've pulled out, just ERASE the config and reboot.

374
Views
0
Helpful
3
Replies