I have several data conversion devices with a 2950 switch being used to route two available multicast addresses to three "destination" ports on the switch. Using "Expect" scripting I am able to login into the switch and configure each port to select one but not both of these addresses.
WhatI would like to know is there a 2950 command(s) I can use to record the selected multicast address going out of any of the destination ports. I would you this result to run a script.
IOS Version 12.1(22)EA1
Using Mulicast VLAN Registration (MVR) for the switch program.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...