Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Recover router

Dear All,

While doing a password recovery on 2691 router, i accidentally changed the config register value to 0x2162 instead of 0x2142. Now i get all junk while booting the router.

Is there a way where i can undo this mistake?

Thanks a lot

Gautam

3 REPLIES

Re: Recover router

Yes, try different baud rates on the terminal until you get the right one. If I have calculated right, 19200 should do the trick.

http://www.cisco.com/en/US/partner/docs/routers/access/2600/hardware/installation/guide/2600appC.html

Kevin Dorrell

Luxembourg

Silver

Re: Recover router

Hi Gautham ,

Chnage the baud rate starting from Min. value to Max.value and check whether you are getting rommon mode at one particular value.

Thanks,

satish

New Member

Re: Recover router

Thanks a lot for your kind inputs. I will let you know.

201
Views
0
Helpful
3
Replies
CreatePlease login to create content