Kindly I need to check if I have an active static route on router and in the same time the route in the EIGRP topology table but 0 successor . If I tried to redistribute EIGRP routes into BGP I need to check if this route will be redistributed into BGP or not
show ip eigrp topology | include 192.168.10.16
P 192.168.10.16/32, 0 successors, FD is Inaccessible
show ip route 192.168.10.16
Routing entry for 192.168.10.16/32 Known via "static", distance 1, metric 0
Route will only be redistributed when route is installed into routing table from the routing protocol which is being redistributed. To redistribute the network 192.168.10.16/32, you need to redistribute static route under BGP.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...