Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Redistributing between two EIGRP AS and setting the Metrics issue

Hello, we have implemented connections between two networks that have different EIGRP AS systems.  We have several connections to this AS 20 network. The issue is with the metrics of the routes to this remote site and asymetrical routing.

The network is this:

AS10             AS20           AS10


Note SIte 1 and site 2 have a connection to each other across the internal AS10 network

From SITE1 it sees a delay of 500010 to at SITE3
From SITE2 it sees a delay of 50010 to at SITE3

So all traffic from AS10 network preferrs to go out tunnel at SITE2

But the problem is at SITE3 it sees the routes to and as equal and prefers to go out the tunnel directly
connected to the site with the tunnel connected at that site, IE for SITE1 its traffic goes OUT SITE2s tunnel but from SITE3
the response traffic goes out its TUN1 directly to SITE1.  This is causing asymetricaly routing and the firewall at SITE1 is
killing the connections.

So to fix this we tried to SET the metrics at SITE1 and SITE2 that it learns from SITE3 to be equal by the following config:

ip access-list standard ALLOW-SITE3-EIGRP

Route-map TO-EIGRP-10 permit 10
  Match ip address ALLOW-SITE3-EIGRP
Router eigrp 10
   Redistribute eigrp 20 TO-EIGRP-10 metric 10000 100 255 255 1400

Unfortunatly what this appears to do is ADD more delay to the existing delay learned from the AS20 instance and what is learned into
the eigrp topo for AS10 for route just has an even larger delay at both sites, and still a none equal cost to each other.

So im wondering if I want to do this instead:

default-metric 10000 100 255 100 1500

ANd if I do this, would apply DELAY statements on teh router with this set still allow adjusting the delay for routes learned via re-distribution??


~ Phil

Cisco Employee

Re: Redistributing between two EIGRP AS and setting the Metrics


If you have a graphical depiction of your network, that would certainly help tremendously.

Also, it would be very helpful to see the show ip eigrp topology and show ip eigrp topology output from both Site 2 and Site 3 to see how did the metrics get set or modified.


Best regards,