Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Redundancy over WAN

Hi

I have a to give a solution to one of my client on WAN redundancy.

They have 2x7206VXR Router at the WAN Gateway for redundancy on Chasis. Their is only one WAN Link. I will be using HSRP to make redundancy in LAN but how can i configure redundacy for WAN on the gateway routers

2 REPLIES

Re: Redundancy over WAN

Hi,

If you mean WAN thru internet.

1. Ask your client to get their own IP Address and ASN. Subscribed to two usptream ISP. Subscribe to two different TELCO to connect them to the upstream ISPs. Run BGP (Public).

2. If your client can't get their own IP Address and ASN. Subscribed to a giant upstream ISP. Subscribed to two TELCO to connect them to this ISP, make an agreement to this ISP that the connection should not be in the same router or in the same building. Run BGP (Private).

If you mean WAN thru your client private network. They can always subscribed to a different TELCO for physical redundancy point-to-point.

Regards,

Dandy

New Member

Re: Redundancy over WAN

HI

Incase if i have two connection to two different routers still how can i make redundacy? by using a cross back-to-back connection? plz need some explanation.

135
Views
0
Helpful
2
Replies
CreatePlease to create content