Hi, I am having a redundant design upgrade request from the client.
Here is the scenario, location A is the servers room, location B is a remote site. There is a 3560 switch at location A and location B and they are connected to ISP WAN at this moment. ISP does the routing and switching.
I need to build a direct connected microwave data link between location A and B as a redundant link. Please check the diagram
On the switch at location B, Gi0/1 is connected to ISP router. Fa0/47 is connected to microwave data link switch. I need to adjust the configuration of the switch such that if the G0/1 interface on the VTS switch is lost then it will pass data from port 47. In this case, how do I change my configure?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...