In my company we purchased two cisco 1941 router for NAT Configuration. We have two ADSL connection and we are planned to configure HA for my firewall. Normally Sonicwall supports static IP for active and passive configuration that's reason I purchased two cisco router with four 10/100/1000 ethernet switch interface card.
I have few doubts to configure the below topology. In Router,Routed interface should connected to ADSL connection for WAN side and LAN side how to configure switch port to connected to both the Firewall.
Please assist how to configure in switch port to connect my active and passive firewall. I need our support to finish this topology in my real Network.
Thanks in advance for your understand and support.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...