Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

REG: Skype

Hi,

Can anyone please suggest me how we can allocate 1mbps to Skpye application and priotize the vioce on Skype.

4 REPLIES

Re: REG: Skype

HI Mohit, [Pls RATE if HELPS]

Command:

---------

ip nbar protocol-discovery.

This will enable nbar discovery on your router.

Cisco released IOS version 12.4 (4) T. Cisco introduced much awaited Skype classification in NBAR.

NBAR configuration for Skype packets:

-------------------------------------

class-map match-any p2p

match protocol skype

policy-map Allow-p2p

class p2p

bandwidth 1024

int FastEthernet0

description WAN_INterface

service-policy input Allow-p2p

Hope I am Informative.

Pls RATE if HELPS

Best Regards,

Guru Prasad R

Re: REG: Skype

I am not sure about your platform where you need to do this

As per Cisco 12.4(4)T Cisco IOS XE Release 2.1 supports classification of skype traffic using NBAR

http://www.cisco.com/en/US/docs/ios/qos/configuration/guide/clsfy_traffic_nbar.html#wp1052372

Narayan

New Member

Re: REG: Skype

Hi,

thanks for the reply

Yes on Release 12.4(4)T. Cisco software supports Skype 1.0, 2.5, and 3.0

can we prioritize the Vioce traffic on Skype or its by default takes priority ?

if has to configured can you plese suggest.

Re: REG: Skype

You will have to prioritise the entire class

Narayan

455
Views
0
Helpful
4
Replies