I am configuring the eigrp under the 3750X with IOS c3750e-universalk9-mz.150-2.SE4.bin, the 'eigrp stub connected summary' is there by default, I tried to NO it, but I could not, what is the purpose of this command by default out there
You are probably running IP Base license. If so, your multilayer switch will only support EIGRP Stub Router functionality, making it suitable for a routed access layer, but it will not be applicable as a distribution layer switch with full EIGRP routing capabilities. If you need full EIGRP routing, you will need to upgrade to IP Services license.
Thanks very much for your answer, it seems the cost to upgrade the lic will be as half amount as the device, the budget is not allowed, any other way to make the full use of EIGRP ? this device will be the main EIGRP HUB WAN device at data center
I am sorry but there is no way of making this device with the IP BASE license a full EIGRP router. This is a license/software imposed restriction - the IOS simply will not unlock the full EIGRP feature set and you won't be able to work around it.
Have you consulted the choice of this device and the feature set/license level with a Cisco partner? Was this device recommended to you from someone else? If so then the responsibility should be shifted to that person.
Hi Peter Thanks and don't be sorry, actually it is replacement of existing 3560G, sometimes it is not our decision to make, though I strongly recommended to use router for WAN device, if the company won't pay guess they might need to do some redistribution confi to make the full eigrp route up and running
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...