06-30-2007 03:23 AM - edited 03-05-2019 05:02 PM
hi
Can anyone tell me abt this error while inserting NME-16ES-1G-P=Etherswitch in 2811 router .
error :% Shuting down Internal GE interface GigabitEthernet1/0 may render inline power for EtherSwitch Service Module not working properly
SETUP: new interface GigabitEthernet1/0 placed in "shutdown" state
Kindly revert back to me.
Rgds
Senthil
07-06-2007 06:12 AM
NM-16ESW-PWR-1GIG is an EtherSwitch network module with Power over Ethernet (PoE) capabilities. After you add this card, you might not be able to configure PoE. This is because you need to have a matching power supply installed on the router to support the PoE features. For more information please click following URL:
http://www.cisco.com/en/US/products/ps5854/products_tech_note09186a008073dc12.shtml#nm1
05-05-2009 08:13 AM
I do have the same problem and non of my ethernet ports do come up. My router is a 2821 and with the IP power supply
05-05-2009 01:47 PM
When you insert this NME into the router, by default the "backplane", Gi1/0, is DISABLED.
Give Gi1/0 an IP Address and "no shutdown" and you should be OK.
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide