Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Regarding error in Cisco 2811 router

hi

Can anyone tell me abt this error while inserting NME-16ES-1G-P=Etherswitch in 2811 router .

error :% Shuting down Internal GE interface GigabitEthernet1/0 may render inline power for EtherSwitch Service Module not working properly

SETUP: new interface GigabitEthernet1/0 placed in "shutdown" state

Kindly revert back to me.

Rgds

Senthil

3 REPLIES
Silver

Re: Regarding error in Cisco 2811 router

NM-16ESW-PWR-1GIG is an EtherSwitch network module with Power over Ethernet (PoE) capabilities. After you add this card, you might not be able to configure PoE. This is because you need to have a matching power supply installed on the router to support the PoE features. For more information please click following URL:

http://www.cisco.com/en/US/products/ps5854/products_tech_note09186a008073dc12.shtml#nm1

Community Member

Re: Regarding error in Cisco 2811 router

I do have the same problem and non of my ethernet ports do come up. My router is a 2821 and with the IP power supply

Hall of Fame Super Blue

Re: Regarding error in Cisco 2811 router

When you insert this NME into the router, by default the "backplane", Gi1/0, is DISABLED.

Give Gi1/0 an IP Address and "no shutdown" and you should be OK.

Hope this helps.

376
Views
0
Helpful
3
Replies
CreatePlease to create content