Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Regarding sh port-channel load-balance.. how can i undo this?

HI Forumer,

can we undo the cmd "sh port-channel load-balance"? need help from forumer here.

TQ

DK

6 REPLIES

Regarding sh port-channel load-balance.. how can i undo this?

http://www.cisco.com/en/US/docs/ios/interface/command/reference/ir_o1.html#wp1013233

port-channel load-balance

To set the load distribution method among the ports in a bundle, use the port-channel load-balance command in global configuration mode. To reset the load distribution to the default settings, use the no form of this command.

port-channel load-balance method module slot

no port-channel load-balance

New Member

Regarding sh port-channel load-balance.. how can i undo this?

if my config as this

"

sh port-channel load-balance forwarding-path interface Po139 src-ip 10.2.16.17 dst-ip 10.2.18.63 vlan 620 src-mac 0015.5d07.ea17 module 3"

so i need to put it like this

" no

port-channel load-balance forwarding-path interface Po139 src-ip 10.2.16.17 dst-ip 10.2.18.63 vlan 620 src-mac 0015.5d07.ea17 module 3"

please advice.

Regarding sh port-channel load-balance.. how can i undo this?

Your asking about a show command, if you dont want to see anything, just dont type it

I think we are having a language barrier.

If you want to put load balancing back to the defaults, you should just have to type no port-channel load-balance, but are you sure this is what you want to do?

From searching Cisco site, looks like you are using a Nexus.  I have zero experience with Nexus, so I am going to defer to someone else who might want to chime in to assist you this morning so I do not give you bad/incorrect info.

New Member

Regarding sh port-channel load-balance.. how can i undo this?

anyway thanks jimmy. u are correct this from nexus 7k.

Any forumers that have experience with nexus?

Re: Regarding sh port-channel load-balance.. how can i undo this

This article might help:

http://www.cisco.com/en/US/docs/ios/interface/command/reference/ir_o1.html#wp1013233

Its for the 5000 series though

Message was edited by: Jimmy Sands

Regarding sh port-channel load-balance.. how can i undo this?

Sent to early, here is the config guide for the 7k

http://www.cisco.com/en/US/docs/switches/datacenter/sw/4_2/nx-os/interfaces/configuration/guide/if_portchannel.html

And in it it says:

Use the no port-channel load-balance ethernet to restore the default load-balancing algorithm of source-dest-mac for non-IP traffic and source-dest-ip for IP traffic.  You can browse the doc though to make sure this is the right one.  Good luck.

511
Views
0
Helpful
6
Replies
CreatePlease login to create content