03-02-2009 02:14 AM - edited 03-06-2019 04:19 AM
Dear Friends,
While reloading a switch with multiple sups, the reload command reloads just the active supervisor. Right?
Is there any command to reload both the sups together? I am talking about 4507/4510RE switches with IOS 12.2(50)SG.
Or the only solution is to type reload twice, once for the active sup and once for the standby sup because it became active?
Thanks a lot
Gautam
03-02-2009 03:38 AM
Gautam,
The reload command will reboot the entire switch. It does include both supervisors.
HTH,
Mark
03-02-2009 10:20 AM
Thanks a lot Mark
03-04-2009 02:14 PM
Hi Gautam
Check ones the command below:
redundancy reload {peer | shelf}
see also other commans like:
redundancy force-switchover
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide