Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reloading a 4507/4510RE switch with dual sup

Dear Friends,

While reloading a switch with multiple sups, the reload command reloads just the active supervisor. Right?

Is there any command to reload both the sups together? I am talking about 4507/4510RE switches with IOS 12.2(50)SG.

Or the only solution is to type reload twice, once for the active sup and once for the standby sup because it became active?

Thanks a lot

Gautam

3 REPLIES

Re: Reloading a 4507/4510RE switch with dual sup

Gautam,

The reload command will reboot the entire switch. It does include both supervisors.

HTH,

Mark

New Member

Re: Reloading a 4507/4510RE switch with dual sup

Thanks a lot Mark

New Member

Re: Reloading a 4507/4510RE switch with dual sup

Hi Gautam

Check ones the command below:

redundancy reload {peer | shelf}

see also other commans like:

redundancy force-switchover

1977
Views
0
Helpful
3
Replies
CreatePlease login to create content