Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

reloading IOS

after a format of flash filesystem. and getting ready to tftp, the switch lost power(long story) after the switch rebooted im at the switch: prompt, and cannot xmodem the ios, I keep getting xmodem denied error.

4 REPLIES
Purple

Re: reloading IOS

You don't say what model so here is the 2950 series procedures.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

New Member

Re: reloading IOS

sorry about that.

its a c3548xl, loading ios c3500xl-c3h2s-mz.120-5.bin

New Member

Re: reloading IOS

New Member

Re: reloading IOS

Heh, cannot believe I miss the : after xmodem.

After I got back into work today I tried again and noticed I was typing copy xmodem flash: NOT copy xmodem: flash:

Now if I can only figure out why I was able to ghost cast 30 laptops with intel NICs in just about 15 mins and why it would take over 3 hours just to ghost cast some PC's with Intel D946GZIS motherboards with onboard NICs.

122
Views
8
Helpful
4
Replies