cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
499
Views
8
Helpful
4
Replies

reloading IOS

stevebybee
Level 1
Level 1

after a format of flash filesystem. and getting ready to tftp, the switch lost power(long story) after the switch rebooted im at the switch: prompt, and cannot xmodem the ios, I keep getting xmodem denied error.

4 Replies 4

glen.grant
VIP Alumni
VIP Alumni

You don't say what model so here is the 2950 series procedures.

http://www.cisco.com/en/US/products/hw/switches/ps628/products_tech_note09186a0080169696.shtml

sorry about that.

its a c3548xl, loading ios c3500xl-c3h2s-mz.120-5.bin

Heh, cannot believe I miss the : after xmodem.

After I got back into work today I tried again and noticed I was typing copy xmodem flash: NOT copy xmodem: flash:

Now if I can only figure out why I was able to ghost cast 30 laptops with intel NICs in just about 15 mins and why it would take over 3 hours just to ghost cast some PC's with Intel D946GZIS motherboards with onboard NICs.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco