Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Remember

Hi.

Just remember.

To add the switch in VTP domain, it must be VTP Transparent and so i change to VTP Client. Correct?

Thanks

1 REPLY

Re: Remember

Hi,

The configuration revision number of the switch must be the lower configuration revision number of the domain. In order to make the revision number equal to zero, BEFORE you plug the switch in the network, you must set the vtp mode to transparent and then revert to client:

vtp mode transparent

vtp mode client.

I hope this helps.

Best regards.

Massimiliano.

107
Views
5
Helpful
1
Replies