Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Remote Span Trouble

Hello.

I have the following configuration.

switch 1 (3560)

========

monitor session 1 source interface Fa0/5 , Fa0/8 , Fa0/10 , Fa0/12 , Fa0/14 - 15 , Fa0/19

monitor session 1 destination remote vlan 40

monitor session 2 destination interface Fa0/23

monitor session 2 source remote vlan 40

switch 2 (3560)

========

monitor session 1 source interface Fa0/17

monitor session 1 destination remote vlan 40

vlan 40 has been created as vlan of remote span in both switches, and are allowed in the trunking on both sides.

If i put a sniffer in the interface Fa0/23 of the switch 1, i only see the traffic of interface Fa0/17 of the switch 2. I expect to see also the traffic of interfaces Fa0/5 , Fa0/8 , Fa0/10 , Fa0/12 , Fa0/14 - 15 , Fa0/19 of the switch 1.

Thanks in advance

1 REPLY
Bronze

Re: Remote Span Trouble

Hi

I think its config mistake.if u would like to see the traffic for int Fa0/5 , Fa0/8 , Fa0/10 , Fa0/12 , Fa0/14 - 15 , Fa0/19 then ur session 1 destination should be towards fa0/23,ie session 1 should be local span.here ur session 1 is mirrored towards the vlan 40 not towards fa0/23.

"monitor session 1 destination interface fa0/23"

226
Views
0
Helpful
1
Replies