vlan 40 has been created as vlan of remote span in both switches, and are allowed in the trunking on both sides.
If i put a sniffer in the interface Fa0/23 of the switch 1, i only see the traffic of interface Fa0/17 of the switch 2. I expect to see also the traffic of interfaces Fa0/5 , Fa0/8 , Fa0/10 , Fa0/12 , Fa0/14 - 15 , Fa0/19 of the switch 1.
I think its config mistake.if u would like to see the traffic for int Fa0/5 , Fa0/8 , Fa0/10 , Fa0/12 , Fa0/14 - 15 , Fa0/19 then ur session 1 destination should be towards fa0/23,ie session 1 should be local span.here ur session 1 is mirrored towards the vlan 40 not towards fa0/23.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...