Is there a procedure for powering off and remove the modules in a 6500? I am going to remove two FWSM and a NAM.
The firewall module should be removed only after you disable power using one of these methods. (There is no preference for a particular method.)
* Use the command-line interface (CLI) of the switch and issue one of these commands. o CatOS - set module power down mod o Cisco IOS® Software - no power enable module slot * Press the shutdown button on the blade. * Physically power down the chassis.
You can remove the module safely when the status light is not green.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.