cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
927
Views
0
Helpful
3
Replies

remove line card 6500

sdaniels44
Level 1
Level 1

I have removed a 16 port line card from a 6509 with sup720's. I do not intend to replace this card, how do I remove the interfaces from the config?

1 Accepted Solution

Accepted Solutions

jphilope
Level 3
Level 3

They will disappear at the next reboot.

View solution in original post

3 Replies 3

jphilope
Level 3
Level 3

They will disappear at the next reboot.

I was hoping that wasn't the case..

Thanks for the info.

Once the card is inserted, and the interfaces are loaded into the tables (ARP/IP/MAC, etc) and the IOS has loaded the microcode for the card, it can't back it out. You'll also see this with sub-interfaces (for instance PVC's under a serial port).

We once had a telco make a mistake and load 250 DLCIs to one of our routers. After all the DLCI's made it into the tables, they were there (under the sho fram pvc command) for quite a while.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: