Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

remove line card 6500

I have removed a 16 port line card from a 6509 with sup720's. I do not intend to replace this card, how do I remove the interfaces from the config?

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: remove line card 6500

They will disappear at the next reboot.

3 REPLIES
New Member

Re: remove line card 6500

They will disappear at the next reboot.

New Member

Re: remove line card 6500

I was hoping that wasn't the case..

Thanks for the info.

New Member

Re: remove line card 6500

Once the card is inserted, and the interfaces are loaded into the tables (ARP/IP/MAC, etc) and the IOS has loaded the microcode for the card, it can't back it out. You'll also see this with sub-interfaces (for instance PVC's under a serial port).

We once had a telco make a mistake and load 250 DLCIs to one of our routers. After all the DLCI's made it into the tables, they were there (under the sho fram pvc command) for quite a while.

429
Views
0
Helpful
3
Replies
CreatePlease login to create content