Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Remove statement

How do I remove the statement "no ip mroute-cache" from my vlan config

!

interface Vlan315

description AGS

ip address 10.10.20.1 255.255.252.0

ip helper-address 10.4.48.1

ip helper-address 10.4.55.5

no ip mroute-cache

!

I had Multicast routing on with the statement "ip pim dense-mode" under the vlan. I removed the multicast routing then removed the statement "ip pim dense-mode" under the vlan and then it auto added the statement "no ip mroute-cache"

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Remove statement

Enter

"ip mroute-cache"

Default commands will not be visible in the config and by default ip mroute-cache is enabled on SVIs.

4 REPLIES
Hall of Fame Super Bronze

Re: Remove statement

Enter

"ip mroute-cache"

Default commands will not be visible in the config and by default ip mroute-cache is enabled on SVIs.

New Member

Re: Remove statement

It's telling me its an Incomplete command

CO-1-MDF(config)#int vlan 315

CO-1-MDF(config-if)#ip mroute-cache

% Incomplete command.

New Member

Re: Remove statement

I found it its "ip mroute-cache distributed"

Thank you...

Hall of Fame Super Bronze

Re: Remove statement

You need the distributed option because multicast fast-switching is done in hardware instead of software on that particular switch.

657
Views
0
Helpful
4
Replies
CreatePlease to create content