Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

removing config

Hello, I was wondering what is the best way to remove configs from ports (GigE or Fa) in a 6500 that we aren't using anymore (i.e. best way to return a port to default).  Remove each line one at a time or is there a command to default a port?  Thanks.

2 REPLIES
VIP Purple

removing config

HI ;

use this

switch(config)#default interface f0/22

Regards

Rate if it helps.

Super Bronze

removing config

Disclaimer

The   Author of this posting offers the information contained within this   posting without consideration and with the reader's understanding that   there's no implied or expressed suitability or fitness for any purpose.   Information provided is for informational purposes only and should not   be construed as rendering professional advice of any kind. Usage of  this  posting's information is solely at reader's own risk.

Liability Disclaimer

In   no event shall Author be liable for any damages whatsoever (including,   without limitation, damages for loss of use, data or profit) arising  out  of the use or inability to use the posting's information even if  Author  has been advised of the possibility of such damage.

Posting

To add to what Sandeep already posted, your IOS might also support range option with default.  Don't recall whether default change shut/noshut, if not don't forget to set as necessary (also with range option, if possible).

135
Views
0
Helpful
2
Replies