I wish to rename my vlans. I have a 4500 core with 3500 edge devices. the core is VTP server and the edge devices are client.
Of course I would like to do this with out disruption (minimal as possible) but do not think that would happen. I think I have to put all of this in transport mode then make the change but then I have to go to each edge devie and manually make the vlan rename changes.
Keep switch in server and client mode dont change .
First create vlan 75 dont remove vlan 50 .
check all the edge switch getting vlan 75. Then change one by one interface with vlan 75 whichever having vlan 50 interface, mean while need to remember svi inteface need to give same subnet ip address in inteface vlan 75 other wise it stop communicating .
After all finishing configuration remove vlan 50 .
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...