Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Renumbered my switch now I'm seeing high loads on interface

I renumbered my 3750 switches over the weekend, and the port that my router is connected to is at > 95% load occasionally. I can't run netflow on these switches, so what do you recommend? I need to figure out why this is so high.

GigabitEthernet5/0/5 is up, line protocol is up (connected)

Hardware is Gigabit Ethernet, address is 0015.f937.6785 (bia 0015.f937.6785)

Description: IT.glazers.info Core-Router

MTU 1500 bytes, BW 100000 Kbit, DLY 100 usec,

reliability 255/255, txload 144/255, rxload 15/255

Encapsulation ARPA, loopback not set

Keepalive set (10 sec)

Full-duplex, 100Mb/s, media type is 10/100/1000BaseTX

input flow-control is off, output flow-control is unsupported

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:00:59, output 00:00:08, output hang never

Last clearing of "show interface" counters 23:32:34

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0

Queueing strategy: fifo

Output queue: 0/40 (size/max)

5 minute input rate 6234000 bits/sec, 4097 packets/sec

5 minute output rate 56676000 bits/sec, 6224 packets/sec

309165083 packets input, 48492636223 bytes, 0 no buffer

Received 15889 broadcasts (0 multicasts)

0 runts, 0 giants, 0 throttles

0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 watchdog, 1763 multicast, 0 pause input

0 input packets with dribble condition detected

483806046 packets output, 569122503579 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 babbles, 0 late collision, 0 deferred

0 lost carrier, 0 no carrier, 0 PAUSE output

0 output buffer failures, 0 output buffers swapped out

The port is trunked to the router, and I haven't noticed it in the past, but it seems that most of the time it's been at least once every 30 minutes that I'm seeing this load. Anything I should look at?

Thanks,

John

HTH, John *** Please rate all useful posts ***
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Bronze

Re: Renumbered my switch now I'm seeing high loads on interface

You can run NetFlow on the router. It should reflect the traffic that is coming from the switch.

__

Edison.

2 REPLIES
Hall of Fame Super Bronze

Re: Renumbered my switch now I'm seeing high loads on interface

You can run NetFlow on the router. It should reflect the traffic that is coming from the switch.

__

Edison.

Re: Renumbered my switch now I'm seeing high loads on interface

Duh....good point. I've been looking at this stuff way too much today. :-)

Thanks,

John

HTH, John *** Please rate all useful posts ***
117
Views
0
Helpful
2
Replies
CreatePlease to create content