Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

REP works with Non-Rep Switch issues

Hi,

I've a ring topology where run REP with Cisco ME-34xx and works fine. However I deployment others 'non-REP' switches in this ring. After do it, a fail betwen non-REP switches, dosen't change the REP topology and keeps the Aternated port in Block state, and isolated non-REP switch. I've used "edge no-neighbor" in the edge non-REP, but as the interface that goes down isn't directly connected, REP doesn't recognize the topology change.

How I can use REP in this kind of situation?

147
Views
0
Helpful
0
Replies
CreatePlease login to create content