Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

replace 3750 switch in stack question

Hello,

If there are 2 stackable switches in a stack and one switch goes bad and is not the master do I need to set priority on the switch first so it wont be the master and also do I need to copy the start-up configuration back to new switch or does the master switch will automatically copy its config to the replacement switch?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

Re: replace 3750 switch in stack question

Hi,

You don't need to copy any config into the new switch.  The master will sync the config to the new member.

Also, the default stack memeber is 1.  As long as your master switch has a priority higher then 1, the new switch will not become the master.

follow this instruction in this link for adding a new switch to the stack

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml#Add

HTH

2 REPLIES
VIP Super Bronze

Re: replace 3750 switch in stack question

Hi,

You don't need to copy any config into the new switch.  The master will sync the config to the new member.

Also, the default stack memeber is 1.  As long as your master switch has a priority higher then 1, the new switch will not become the master.

follow this instruction in this link for adding a new switch to the stack

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_configuration_example09186a00807811ad.shtml#Add

HTH

New Member

Re: replace 3750 switch in stack question

Thanks.

363
Views
0
Helpful
2
Replies
CreatePlease login to create content