Replacement of Netgear FVX538v2 with Cisco Router 29xx?
Dear Cisco community,
as my Netgear FVX538v2 router recently died I would like to replace this router by an enhanceable Cisco product. I'm thinking of a Cisco 2901 model that will be connected to the cable modem of my ISP and has to support PPPoE over the WAN port. The Cisco router should provide the following physical interfaces:
+ 2 WAN ports (10/100/1000 Mbps, RJ-45)
+ 8 LAN ports (10/100/1000 Mbps, RJ-45)
+ Serial Port for terminal program access
+ other options the FVX538v2 does provide
Will a Cisco Router 2901 be sufficient to replace a Netgear FVX538v2 device?
What modules do I have to purchase?
What additional licenses (data, UC, Sec?) do I have to pay for?
I'm sorry but it seems to me that I got lost in the Cisco Router product forest ...
Thank you very much in advance for any help and advise!
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...