05-06-2014 02:46 AM - edited 03-07-2019 07:20 PM
same IOS version
WS-C2960S-24PS-L
for
WS-C2960S-48LPS-L
Whats the best way to do this without powering down the stack.
thanks
Solved! Go to Solution.
05-06-2014 03:06 AM
05-06-2014 03:54 AM
If you use your method, there will be MORE disruption to clients connected to switch 3 because you need to reboot switch 4/3 TWICE.
With my method, your disruption is minimized to just ONE disruption.
Your choice.
05-06-2014 03:06 AM
05-06-2014 03:08 AM
will the stack detect the 48 port switch and allow me to config all its ports or will it still remember only 24 ports ?
05-06-2014 03:16 AM
Let us presume that your 24-port is switch 3 in the stack. So you can remove the configuration of the 24 port by using this command:
config t
no switch 3 provision WS-C2960S-24PS
switch 3 provision WS-C2960S-48LPS
<You can start configuring your ports EVEN BEFORE you connect the 48-port switch to your stack>
end
Please don't forget to rate our useful posts.
05-06-2014 03:20 AM
Thanks
the stack contains 3 switches
could i provison the new switch as number 4 and config the ports
then remove switch 3 and convert switch 4 to number 3?
05-06-2014 03:54 AM
If you use your method, there will be MORE disruption to clients connected to switch 3 because you need to reboot switch 4/3 TWICE.
With my method, your disruption is minimized to just ONE disruption.
Your choice.
05-06-2014 04:22 AM
OK
but i gain time configing the ports before (multiple vlans)
as you say ... my choice
thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: