Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Reset cf:1 on IDS module sent SUP720 into ROMMON

Greetings

I had a really weird and worrying problem today. In preperation to reimage an IDSM2 module in a Catalyst 6500 with SUP720 and IOS 12.2(18)SXF3 I sent the "hw-module module 5 reset cf:1" command in a telnet session to the switch.

This caused the switch to drop from the network and when I was able to set up a serial connection to the switch I found the SUP720 had rebooted into ROMMON.

The SUP720 is in slot 7 and the IDS in slot 5. Neither buffer log or syslog show any indication of what happened and I'm positive I sent the correct command.

Any ideas?

2 REPLIES
Silver

Re: Reset cf:1 on IDS module sent SUP720 into ROMMON

Do a 'dir bootflash:' and see if this left a crashinfo file. If so, open a TAC case and let us decode it.

New Member

Re: Reset cf:1 on IDS module sent SUP720 into ROMMON

Hi

Thanks for the answer. Actually the Catalyst wrote a crashinfo. It confirms me sending reset module 5. I'll try to start a TAC right away. However the TAC seems to be broken at the moment.

159
Views
0
Helpful
2
Replies